Aircol 150 K

Provides optimum protection against external factors such as dust, malodor or cold when the fan is not operated thanks to the aesthetic back cover.
Specially designed back cover with pull cord which acts as an on-off switch.
Provides the highest possible protection against external factors such as malodors and moisture, and maintains its initial appearance thanks to the high-quality ABS plastic material used.
Back cover, body and impeller can be easily cleaned by being rubbed off.
Minimum sound level thanks to the optimum motor and body design.
Self lubricating motor bearings offer a silent and long-life performance.
The equipment can be installed on windows (3 mm – 7 mm) with ease.
Very simple installation thanks to the installation cord given with the product.
Suitable for any type of ducts and places with various sizes thanks to two models with different dimensions (Ø160, 210 mm).
IPX4 protection against water splash.
All products are manufactured in accordance with the EN 60335-2-80, Low Voltage Equipment [2014/35/EU] and Electromagnetic Compatibility [2014/30/EU] norms.

Fields of Use

Technical Properties

Dimensions

Performance Curves

Installation

Big and medium sized places:
Suitable for ventilation of kitchens, bathrooms, offices, workplaces, storerooms, garages, etc.
Suitable for discharging polluted inside air with direct installation (without use of any connection duct).

OPTIONS OF USE

	Manual use with the back cover acting as an on-off switch with its pull cord.
	The fan can be provided to continue to operate for a certain length of time after being switched off, by use of a time delay electronic card.
	Thermal protection with sensors against overheating in hot places.

Voltage/Frequency	(Volt/Hz)	230/50
Current	(A)	0.23
Power	(Watt)	20
Air Flow	(m³/hour)	350
Speed	(Rpm)	2300
Pressure	(Pa)	30
Sound Pressure Level (@3m)	(dB (A))	30
Min. / Max. Ambient Temperature	(ºC)	-30 / 40
Material		ABS plastic
Protection Class / IP		II / IPX4
Motor Insulation Class		B
Approval		TSE
Certification		CE

MODEL	A	B	C	D	E
AIRCOL 150 K	210	82	179	41	158

1- Create a hole of Ø190~ Ø192 mm.
2- Place the silicone ring given with the product in the hole as seen in the figure, in the manner that its grove is located on the glass.
3- Afterwards, place firstly the upper part and then the lower part of the fan in the silicon ring.