Aircol 25 K

Provides optimum protection against external factors such as dust, malodor or cold when the fan is not operated thanks to the aesthetic front cover.
Front cover with pull cord provides ease of opening and closing.
Provides the highest possible protection against external factors such as malodors and moisture, and maintains its initial appearance thanks to the high-quality ABS plastic material used.
Front cover, body and impeller can be easily cleaned by being rubbed off.
Minimum sound level thanks to the optimum motor and body design.
Self lubricating motor bearings offer a silent and long-life performance.
The equipment can be installed on windows and thin plates with ease.
Very simple installation thanks to the installation ring given with the product.
Suitable for any type of ducts and places with various sizes thanks to two models with different dimensions (Ø180, 230 mm).
IPX4 protection against water splash.
All products are manufactured in accordance with the EN 60335-2-80, Low Voltage Equipment [2014/35/EU] and Electromagnetic Compatibility [2014/30/EU] norms.

Fields of Use

Big and medium sized places:
Suitable for ventilation of kitchens, bathrooms, offices, workplaces, storerooms, garages, etc.
Suitable for discharging polluted inside air with direct installation (without use of any connection duct).

OPTIONS OF USE

	Can be directly controlled with an on-off button, or operate in parallel connection to a lamp.
	The fan can be provided to continue to operate for a certain length of time after being switched off, by use of a time delay electronic card.
	Thermal protection with sensors against overheating in hot places.

MODEL	A	B	C	D
AIRCOL 25 K	308,6	138,4	230	80

Installation on Glazing

Create a hole of Ø260~ Ø265 mm.
Place the fan in the hole as seen in the figure.
Lastly, install the bracket on the fan body by use of the four sheet metal screws (3.5x25) given with the product.

Installation on Wall

Create a hole of Ø260~ Ø265 mm.
Place the fan in the hole as seen in the figure.
Lastly, install the bracket on the fan body by use of the four sheet metal screws (3.5x25) given with the product.